135HP Mining Grader Motor GR165

Motor grader GR135 135hp new small motorgrader with ripper.

 Motor grader with ripper GR135 is mainly used for ground leveling, ditching, slope scraping, bulldozing, scarification, snow removal for large areas such as highway, airports, farm-lands etc. 

Motor grader GR135 is the necessary construction machinery for national defense construction, mine construction, urban and rural road construction and water conservancy construction, farmland improvement and so on.

1. GR135 adopt Dongfeng 6BT5.9-C130- II turbocharged diesel engine, Large output torque and power reserve coeficient and low oil consumption.

2. Torque converter has big torque coefficient, wide high efficiency area. It has good combination working characteristics with engine. The transmis- sion box has six forward gears, three backward gears, with neutral start

protection function, gear shift controlled by electro-hydraulic, flexible operation, shift without impact, reasonable speed ratio distribution, meet the requirements of various working conditions.

3. The rear axle adopts balanced suspension to ensure the uniform load of four wheels, which is conducive to the full use of its adhesion ability. The main drive of the rear axle is equipped with"NO – SPIN" self-locking differential.

4. The front axle is steering axle. The axle can swing from side to side. In addition to the front steering, it also uses the articulated frame, which can further reduce the turning radius.

5. The hood is structural part, well shaped with turn over function, the two sides double door is reversible, enhances the maintainability.
 

• Description		Unit	Parameter value
  Engine model			Cummins 6BT5.9-C130-2
  Rated power/speed		kw(r/min)	97(2200)
  Overall dimension (standard)			8015X2380X3050
  Total weight (standard)		kg	11000
  Tire specification			13.00-24
  Ground clearance (front axle)		mm	515
  Tread		mm	2020
  Space of front and rear axles		mm	5780
  Forward velocity		km/h	5/8/13/20/30/42
  Reverse speed		km/h	5/13/30
  Tractive effort f=0.75		kN	61.3
  Maximum gradeability		%	20
  Tire inflation pressure		kPa	300
  Working system pressure		MPa	16
  Transmission pressure		MPa	1.3-1.8
  Maximum steering angle of front wheel			±49°
  Maximum slant angle of front wheel			±17°
  Maximum oscillating angle of front axle			±15°
  Maximum oscillating angle of equilibrium box			±16°
  Maximum steering angle of frame			±27°
  Minimum turning radius		m	6.6
  Scrape knife	Maximum lift height	mm	410
  	Maximum cutting depth	mm	515
  	Maximum tilt angle		90°
  	Cutting angle		54°-90°
  	Angle of revolution		360°
  	Length & chord height	mm	3048×610

Picture

Our company